HamLog - amateur radio contact logger.

Looking for PSION Organiser II Software
User avatar
MartinReid
Posts: 102
Joined: Wed Jan 27, 2021 3:44 pm

HamLog - Typing in programs

Post by MartinReid »

Yes keep going.. The HLog program is quite long... If you need to stop partway through you can use [Prog] [Save] to save your work so far. Then [Prog] [Edit] to continue later... It will not [Run] until it is [Tran]slated.. You can use [Prog] [Dir] to see what programmes are there.
hawsey
Posts: 46
Joined: Fri Jul 02, 2021 12:34 am

Re: HamLog - amateur radio contact logger.

Post by hawsey »

Can't believe how long it took to type in 😂

Ok on Trans I can't get past HLutils , I get error Syntax error , up to that point I corrected a few mistakes like a missing space , but now I'm stuck .
hawsey
Posts: 46
Joined: Fri Jul 02, 2021 12:34 am

Re: HamLog - amateur radio contact logger.

Post by hawsey »

Ok scrub that , I had it on a separate line that was the issue .
hawsey
Posts: 46
Joined: Fri Jul 02, 2021 12:34 am

Re: HamLog - amateur radio contact logger.

Post by hawsey »

So I continued with Trans until I got no more errors .
Now going to" Prog" Then" Run" I get issues , if I select HLOG I get error bad file name , edit A Hlog y/n.
Any ideas please .
User avatar
MartinReid
Posts: 102
Joined: Wed Jan 27, 2021 3:44 pm

Re: error bad file name

Post by MartinReid »

Right this is a tricky one to find.. but you are nearly there..

[EDIT] If you reply with Yes to the Edit Hlog Y/N the Organiser will open the file and the cursor will be where the error was found.. Keep reading below to see what the error might be..

error bad file name
Check you have given these progams the correct names inside HLOG
Look at the listing on page one of this forum post so you can see where they are then cursor down on the Organiser until you find them. Make sure they are spelt correctly and only have one colon after their name (:)

HLUDG: (used only once)
AP: (used 5 times)
HLTOP:(2) (used twice)

If it is not the above then it may be the goto labels they must have two colons (::) after their name. (without that Organiser assums they are an extenal file, whick it can't find) You'll need to check every occurance of them. Check for spelling and the double colon (::)
SETNUL:: (used 3 times)
LOOP:: (used 4 times)
NAME:: (twice)
CSign:: (twice)
Htz:: (twice)
LOG:: (twice)
SETNUL:: (used 3 times)

I'm reasonably sure that's what it will be. also you may have repeated the error so keep checking until it runs.
Always sincere
Martin

You are going to love it when you get it running
hawsey
Posts: 46
Joined: Fri Jul 02, 2021 12:34 am

Re: HamLog - amateur radio contact logger.

Post by hawsey »

Martin ,
Thank you, I need to go through it again with a fine tooth comb, I'm sure I will love it . 👍
hawsey
Posts: 46
Joined: Fri Jul 02, 2021 12:34 am

Re: HamLog - amateur radio contact logger.

Post by hawsey »

Well , I think I'm stuck again , I have got to the point where everything is translated and saved and errors that I have seen , corrected .
Now when I go to Prog run then HLOG , I get ERROR ARG COUNT ERR .
When I select edit it brings me to the line ending
+B.TXT$+CHR$(26))
which looks ok to me .
Any ideas please .
User avatar
MartinReid
Posts: 102
Joined: Wed Jan 27, 2021 3:44 pm

Re: HamLog - amateur radio contact logger.

Post by MartinReid »

Probably another typing error... check the whole line carefully

AP:(1,2,"Text:"+B.TXT$+CHR$(26))

Commas, full stops, quotes.. everything

That will be it..
Martin
hawsey
Posts: 46
Joined: Fri Jul 02, 2021 12:34 am

Re: HamLog - amateur radio contact logger.

Post by hawsey »

MartinReid wrote: Fri Jul 30, 2021 6:07 pm Probably another typing error... check the whole line carefully

AP:(1,2,"Text:"+B.TXT$+CHR$(26))

Commas, full stops, quotes.. everything

That will be it..
Martin
I re typed the line as I was sure it was correct , but with the same error above .
At Run A:* I have
AP 103
HLUDG 136
HLTOP 179
HLOG 2565

Do those numbers look correct ?
Sorry to be a pain but I'm stumped here , I'm sure I'll get there in the end .
hawsey
Posts: 46
Joined: Fri Jul 02, 2021 12:34 am

Re: HamLog - amateur radio contact logger.

Post by hawsey »

hawsey wrote: Fri Jul 30, 2021 8:36 pm
MartinReid wrote: Fri Jul 30, 2021 6:07 pm Probably another typing error... check the whole line carefully

AP:(1,2,"Text:"+B.TXT$+CHR$(26))

Commas, full stops, quotes.. everything

That will be it..
Martin
I re typed the line as I was sure it was correct , but with the same error above .
At Run A:* I have
AP 103
HLUDG 136
HLTOP 179
HLOG 2565

Do those numbers look correct ?
Sorry to be a pain but I'm stumped here , I'm sure I'll get there in the end .

Ok scrub that , I've got it I think , there was a problem in AP
I'll have a play now 😃
Post Reply